Outboard Motors, 4 Stroke 4Hp 55cc Air-cooled Boat Engine Outboard Boat Motor

Features:
1, High Performance: Four-stroke power, less noise, fuel saving. Started by hand, simple and convenient. With reverse function for operation flexibly.
2, Applicable Ship: 4hp outboard is suitable for small boats of various materials (such as inflatable boat, iron boat, plastic boat, glass fiber reinforced plastic boat, wooden boat, etc.).
3, The product comes with a funnel, kit, and cotter pin.

Engine Start Procedure:
(1) Insert the emergency flameout cable insert into the flameout switch slot.
(2) Insert the fuel inlet pipe inlet plug into the fuel tank socket.
(3) Insert the nozzle plug into the tubing socket on the base of the outboard.
(4) Unscrew the vent screw on the fuel tank cap counterclockwise.
(5) Squeeze the hand core pump by hand several times until the oil pump is full of fuel and feel the hand pump hard.
(6) Move the shift lever to the “Neutral” position.
(7) Turn the throttle lever to the “start” position, ie the start mark on the handle is aligned with the arm mark.
(8) When the engine is cold, pull out the choke lever to increase the concentration of the combustible mixture and make the engine easier to start.
(9) After the handle is started by hand, the claw of the starter is engaged with the flywheel, and the start rope is quickly pulled out to start the engine.
(10) After the engine is started, the engine should be warmed up for 2 to 3 minutes at an idle speed, and then the choke levers are all pushed to the initial position.
(11) After the engine is started, it should be noted that the cooling water is steadily flowing out. If there is no water or intermittent water, the reason should be stopped.
(12) During the driving, the flameout rope should be hung on the wrist or belt to ensure the safety of the boat.

Note: The outboard motor has been run-in and commissioned for 4 hours before leaving the factory. The four-stroke outboard oil tank can only be filled with pure gasoline. The oil tank should use four-stroke special oil. The oil should be filled according to the scale on the oil scale. Check if the oil is sufficient before using the machine.

Specifications:
Item Name: Outboard Motors
Material: Metal + Plastic
Engine Model: four strokes 4 horsepower
Displacement: 55cc
Transmission Ratio: 2.08 (27:13)
Number of Cylinders: 1
Maximum Power: 2.9kw
Maximum Speed: 4500-5500r/min
Shift Position: clutch
Ignition System: CDI
Cooling System: wind cooling
Control System: tiller control
Startup Mode: manual start
Refueling Method: recommended 92# unleaded gasoline
Cylinder Diameter * Stroke: 44 * 33
Propeller Specifications: 3-7 1/4"*5"
Recommended Oil: four-stroke engine oil
Inclined Tilt System: manual tilt
Standard Fuel Tank Capacity: 1.4L
Adaptation Stem Board Height: 440mm
Product Weight: 10300g
Product Dimensions: 36.5 x 22 x 92cm
Package Weight: 13400g
Package Dimensions: 95 x 42 x 29cm
Packing: Carton Box

Package Content:
1 x Outboard Motors
1 x funnel
1 x kit
1 x cotter pin