Horizontal Water-cooled Gasoline Combustion Engine Hit Miss Complete Engine with Hand Starter

Features:

It's an old-fashioned gasoline horizontal-type engine that cools with water. The valve mechanism is mounted on the left side of the engine and has a distinctive cylinder head design. The side gear drive mechanism to control the exhaust shutdown is compact, which adds to the processing difficulties of the side valve structure.

The gear is a 90-degree helical gear.

A speed restriction on the left flywheel is attached to a sizable angle in the center of the wheel.

The engine's distinctive design and wooden foundation make it simple to install and use.

Value: An advanced metal craft internal combustion engine model with a well-processed, easily operable construction. A fantastic personality present for friends or model enthusiasts

Engine startup steps:

1. Open the bottom plate to check the engine's wiring, connect the fuel tank pipe, and install the three AA batteries to close the bottom plate.
2. Fill the fuel tank with gasoline (95#). When the filling is completed, ensure no air is in the oil pipe.
3. On the right side of the engine (installation of the flying hammer position), slowly turn counterclockwise by hand to buy more than one
turn, it makes the mixed gasoline fully enter the cylinder.
4. Turn on the power switch and turn the flywheel to start the engine counterclockwise on the right side of the engine (installation of the flying hammer position).

Precautions:

1. If the ignition device is standard and the cylinder is under standard compression, if the machine still does not start usually, it is very likely that the carburetor needle should be adjusted.
2. Screw the screw on the top of the carburetor, then loosen 1/4 turn and start the flywheel. This can be done several times to make the mixing ratio of gasoline and air

For more engine reviews, please click here.

Specifications:

.Color: As Shown
.Material: Brass + Stainless Steel + Wood
.Item: Horizontal Hit and Miss Complete Engine
.No.: M94
.Wooden Base: 180 x 66 x 50mm
.Displacement: 6CC
.Cylinder Diameter: 22mm
.Stroke: 20mm
.Revolutions: Approximately 1200rpm
.Power Supply: 3 x AA batteries (Not Included)
.Fuel: 95# Gasoline
.Product Size: 18 x 12.5 x 12.5cm
.Product Weight: 1610g
.Package Dimensions: 25 x 25 x 25cm
.Package Weight: 2200g
.Packing: Carton Box

Package Content:

.1 x Model Engine
.1 x Hand Starter
.1 x Manual